JOES Micro Sprint Steering Rack (V3)
The lightest steering rack on the market, now better than ever. JOES updated this thing with a new case seal design that closes off 95% of the bottom — way less dirt and crap getting inside, way less grease and maintenance needed to keep it happy.
The internals got beefed up too. Wider linear gear means the load's spread over more surface area, so it wears slower and lasts longer. All while keeping the same outside dimensions as the old version — bolts right in.
What you're getting:
6061-T6 aluminum body, lightweight aluminum rack
Hardened and plated steel heim bracket — and it's the only replaceable bracket on the market. Bend it? Order a new tab, swap it out yourself, keep racing
Full ball bearing control for smooth, consistent feedback
Two grease zerks on the outside for quick maintenance
Tears down completely for a deep clean in minutes
Built start to finish in JOES' shop in the USA.
V3 Specs:
Ratio: 12:1
Travel: 6½"
Weight: 2.9 lbs
Input shaft: ⅝"-36 spline, 4130 solid chromoly (use SWE401-50607 U-joint)
Overall length: 14 ⅛"
Thickness: 1 ⅝"
Mounting holes: 3" apart, center to center
Fits:Coyote Race Car chassis, JOES, Apex, Lynk, Royal, B&B, D1, TenJ, Pace, PMP, Edge
JOES Micro Sprint Steering Rack (V3)
The lightest steering rack on the market, now better than ever. JOES updated this thing with a new case seal design that closes off 95% of the bottom — way less dirt and crap getting inside, way less grease and maintenance needed to keep it happy.
The internals got beefed up too. Wider linear gear means the load's spread over more surface area, so it wears slower and lasts longer. All while keeping the same outside dimensions as the old version — bolts right in.
What you're getting:
6061-T6 aluminum body, lightweight aluminum rack
Hardened and plated steel heim bracket — and it's the only replaceable bracket on the market. Bend it? Order a new tab, swap it out yourself, keep racing
Full ball bearing control for smooth, consistent feedback
Two grease zerks on the outside for quick maintenance
Tears down completely for a deep clean in minutes
Built start to finish in JOES' shop in the USA.
V3 Specs:
Ratio: 12:1
Travel: 6½"
Weight: 2.9 lbs
Input shaft: ⅝"-36 spline, 4130 solid chromoly (use SWE401-50607 U-joint)
Overall length: 14 ⅛"
Thickness: 1 ⅝"
Mounting holes: 3" apart, center to center
Fits:Coyote Race Car chassis, JOES, Apex, Lynk, Royal, B&B, D1, TenJ, Pace, PMP, Edge
